AQUENCE PL120

Scope of application

• Gluing veneer and laminates of HPL and CPL on chipboard, plywood board, etc.
• Veneering of flat surfaces in a hot press from 40 °C (104°F)

Product Properties

• Variance based on PVA
• High solid residue content
• Medium viscosity
• Single - component
• Short setting time
• Does not stain the tool
• Provides a moisture-resistant adhesive seam (class D2 according to EN 204)High initial bonding strength

Technical data

• Film formation temperature, °C ~+18
• (MFFT)
• DIN 53787
• Viscosity, according to Brookfield, MPa * s - 9 000-11 000ISO 2555
• pH - 4,5-6(20 °C)
• ISO 976

Open time

Open time at 20 °C:
Consumption 100 g/m2, min. ~3
Consumption 200 g/m2, min. ~6

Pressing time (at approx. 0.5 N/mm2, at 40°C)

Glued materials (chipboard and HPL):
chipboard / veneer about 100 g/m2, sec. ≥180
chipboard / HPL about 100 g/m2, sec. ≥240

These data are valid for wood with a humidity of 8-12%, the temperature of the material and the room is not lower than 20 ° C, the relative humidity of the air is 65% and the pressure is 0.5 N/mm2. The actual open time and pressing time will depend on the working conditions, such as temperature, humidity and density of wood, surface properties, stresses in the material, the amount of glue applied, etc.Before the next stage of bonding, the parts must be cooled to room temperature. Practice shows that increasing the pressing time does not improve the results. On the contrary, it worsens the quality of bonding, for example, leads to the opening of the adhesive seam.The glue is ready to use and does not need to be diluted with water.The working temperature of the adhesive and the processed parts must be at least + 10 °C.

Recommended glue consumption g/m2: 80-120

Clearing
Cleaning of glue-bearing equipment from uncured glue residues can be carried out with cold or warm water. Solidified residues are removed mechanically.

STORAGE
Store in the original tightly sealed packaging in a cool, dry place, protect from freezing. Mix before use.Shelf life up to 12 months.